WELCOME TO OUR BLOG

We're sharing knowledge in the areas which fascinate us the most
click

Discussion on Transformer Inrush Current

By azhe June 11th, 2025 396 views

I. What is Inrush Current?

When a transformer is first energized or put back into service after a fault, due to the nonlinear characteristics of the core magnetization curve, there might be a transient current much higher than normal operating currents. This phenomenon is known as inrush current. The inrush current not only poses a threat to the transformer itself but may also affect the stable operation of the power system.

II. Causes of Inrush Current

1. Hysteresis Effect

Transformer core materials exhibit hysteresis, meaning there is a lag between magnetic induction B and magnetic field strength H. When a transformer is initially powered up, the flux in the core increases rapidly, leading to quick traversal of the saturation point on the hysteresis loop, which triggers significant excitation current.

2. Saturation Phenomenon

As voltage is applied, the core gradually enters the saturation region where permeability drops sharply. To maintain a certain level of flux density, larger excitation currents are required, further intensifying the magnitude of the inrush current.

3. Initial Phase Angle

The moment a transformer connects to the grid, if the supply voltage is near its peak, it can lead to a greater inrush current because the rate of change of flux is at its maximum then.

III. Hazards of Inrush Current

1. Impact on Transformers

  • Mechanical Stress: Electromagnetic forces caused by high currents can lead to winding deformation.
  • Thermal Effects: Excessive currents generate excessive heat, accelerating insulation aging.

2. Impact on the Grid

  • Voltage Fluctuations: Inrush currents can cause local grid voltage dips.
  • Misoperation of Protective Relays: Large inrush currents might trigger circuit breaker trips or actions from other protective devices.

IV. Methods to Suppress Inrush Current

1. Using Current Limiting Resistors

During initial operation, series-connect current-limiting resistors with the transformer and short-circuit them once the current stabilizes.

2. Proper Timing for Closing Switches

By controlling the timing of closing switches, avoiding doing so when the voltage is near its peak can effectively reduce inrush currents.

3. Soft Start Technology

Employing soft start technology, gradually increasing voltage to its rated value allows the core to slowly reach the saturation state, thereby reducing inrush currents.

Transformer Losses and Their Calculation Methods
Previous
Transformer Losses and Their Calculation Methods
Read More
Interpretation of the Relationship Between Rated Voltage and Voltage Ratio in Single-phase Transformers
Next
Interpretation of the Relationship Between Rated Voltage and Voltage Ratio in Single-phase Transformers
Read More
Leave a message
Name *
Email *
Message *
Enter your email to hear from us about Product list, Latest Products and Customer application examples!
Verification Code *
Click to verify